Elgar CW 1251P-V Especificações descarregar pdf (Página 56)

Programming Elgar CW-P Series

4-4 Operation Manual

4.3 Menu Operations

There are two buttons in the Menu section of the front panel, ENTER/SAVE and

ESCAPE. Press the ENTER button to enter the Menu system. The MENU/STATUS

LED lights and the left and right displays are overridden to provide menu system

readouts. When in the Menu mode, the two MEASURE and two PROGRAM LEDs are

all turned off.

Use the Menu system to display and/or change the following parameters:

• Check the self-test result

• Set the GPIB port address

• Specify current Foldback/Shutdown

• Specify current shutdown delay

• Specify PROGRAM keys lock out

• Store system parameters

• Recall system parameters

• Specify whether the output relay will automatically close at power-up

• Specify Clock Signal as an Input or an Output

• Analog input

• RMS loop On/Off

• Phase A offset

• Phase B offset

• Phase C offset

• Slave channel

• Slave address

• Slave configuration

The menu is flat in its design and the various major nodes are available by rotating the

left knob either clockwise or counterclockwise to move either down or up on the list

given here.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 62

Sem comentários

Elgar CW 1251P-V Especificações Página 56